Table of Contents
Advertisement
6. Operation Instructions
6-1 Front panel controls
Control Panel Function
1. POWER Press to turn on and off the TV.
2. INPUT
3. MENU
4. VOL-
5. CH-
6. Power indicator
7. Remote Sensor
6-2 Back panel controls
1.ANT IN(Antenna Input)
2.Headphone jack : Headphone audio output terminal.
3.Audio in
4.S-VIDEO
5.Audio in
6.Video in
7.USB input Connect a USB flash drive to view JPEG images or listen to MP3
8.VGA
9.PC audio in Connect the audio output from the pc to the PC audio input port.
10. HDMI: Connect a HDMI device to receive digital audio and uncompressed
11. Component Input Connect a component video device to these jacks.
6-3 Setting Up Your Remote Control
After it has been set up properly, your remote control can operate in six different modes:
TV, VCR, CABLE, DVD, SETBOX or AUDIO. Pressing the corresponding button on the remote
control
Selects the input signals.
Menu display. Press to access the on-screen menu display.
Volume down / Left button to adjust the item in the OSD.
VOL+ Volume up / Right button to adjust the item in the OSD
/Press to enter.
TV channel down / to select the item in the menu.
CH+
TV channel up / to select the item in the menu.
Receivers IR signals from the remote control.
Do not put anything near the sensor ,which may
block the remote control signal.
ATN IN
R-AUDIO-L
S-VIDEO IN
Pr
Pb
Y
COMPONENT IN
Connect audio output from an external device to these jacks.
Connect S-Video out from an S-Video device to the jacks.
Connect audio output from an external device to these jacks.
Connect video output from an external device to this jack.
songs.
Connect to the VGA 15PIN analog output connector of a PC
graphics card to use set as a PC display.
digital video.
INPUT
MENU
VOL-
VOL+
R1
K1
series
R-AUDIO IN-L
VIDEO
USB
VGA IN
Connect cable or antenna signals to the TV, either
directly or through your cable box.
Service Manual
Model No.: HL24XP1
CH-
CH+
POWER
1
series
F series
PC AUDIO IN
HDMI
23
Advertisement
Table of Contents
