Waterax Mini-striker series Quick Manual

Waterax Mini-striker series Quick Manual

Portable single-stage pump end paired with a honda gxh50 gasoline engine

Advertisement

MINI-STRIKER Quick Guide
This Quick Guide shows the basic operation of the WATERAX
MINI-STRIKER portable pump.
The WATERAX MINI-STRIKER is a portable single-stage
pump end paired with a Honda GXH50 gasoline engine.
For instructions regarding the engine, as well as for oil and
fuel recommendations, please refer to the engine
manufacturer's manual.
For detailed instructions on using and troubleshooting your
pump, as well as full service and maintenance instructions,
refer to our website to download the MINI-STRIKER
Owner's Manual.
For full specifications and performance curves, see the
MINI-STRIKER Data Sheet.

Warnings and Safety Precautions

This warning label appears on all WATERAX pumps to identify safety
hazards as follows:
READ YOUR ENGINE MANUAL!
Before proceeding further, locate and read the engine
manufacturer's manual. It contains very important safety
information that MUST be read, understood and followed to
safeguard you and your equipment from harm, as well as for
the proper use and care of your engine. Use only fuel and
oil type recommended in the engine manufacturer's manual.
Always check oil level in crankcase before use.
WEAR EAR AND EYE PROTECTION.
Always wear eye and ear protection when operating the
pump unit. Sound level of the unit: 91 dB(A).
GENERAL WARNINGS:
Do not operate if mentally or physically fatigued.
Inspect hoses and piping to avoid burst injuries.
No modifications and/or alterations may be made to the
pump. Any such modifications void the pump warranty
and can endanger pump operators.
Do not operate the pump above the maximum rated
pressure. Use only pipe, hose, and fittings rated at or
above the maximum pressure rating of the pump or
system design.
Slowly close valves. Use slow close valves wherever
possible to safeguard operators and prevent damage
from water hammer.
Dry weight of the unit: 20 lbs.
01/2015
READ THE PUMP OWNER'S MANUAL!
The improper use of this pump could result in serious injuries
as well as damage to the unit. Read the MINI-STRIKER
Owner's Manual before using your MINI-STRIKER pump unit
and follow the safety instructions in this Quick Guide.
NEVER RUN THE ENGINE IN A CLOSED
OR CONFINED AREA. Exhaust gas contains
carbon monoxide which is poisonous to humans.
Avoid inhalation of exhaust gas.
REFUEL ENGINE WITH CARE. Gasoline is
extremely flammable, and gasoline vapor can
explode. Refuel in a well-ventilated area, with the
engine stopped.
NEVER TOUCH ANY EXHAUST SYSTEM
PARTS WHILE ENGINE IS RUNNING. Always
allow enough time, after stopping the unit, for proper
cooling of these parts and surrounding areas.
EQUIPMENT DAMAGE PREVENTION:
Flush the pump with fresh water if the pump has been
used to pump salty, brackish, high mineral content
water, water containing debris, or foam injected water.
Check that debris is cleared before using the pump
again.
Always draft water using a suction hose strainer.
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Mini-striker series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Waterax Mini-striker series

  • Page 1  For full specifications and performance curves, see the MINI-STRIKER Data Sheet. Warnings and Safety Precautions This warning label appears on all WATERAX pumps to identify safety hazards as follows: READ YOUR ENGINE MANUAL! READ THE PUMP OWNER’S MANUAL! Before proceeding further, locate and read the engine The improper use of this pump could result in serious injuries manufacturer’s manual.
  • Page 2: Parts Identification

    3. Connect discharge hose, nozzles, etc., to pump, and tighten firmly with coupling wrench. 4. Prime the pump Use a WATERAX hand primer. Pump can also be primed by “jerking” the suction hose until water flows from the pump’s discharge port.
  • Page 3 MINI-STRIKER Quick Guide 6. Discharge water. Once the pump is primed, and with the engine running, you DO NOT leave the pump running with all the can begin to discharge water. discharge valves closed for more than one minute, or a.
  • Page 4 WATERAX can be found on our Web site at: www.waterax.com WATERAX Inc. 6635 Henri-Bourassa W. Montreal, QC H4R 1E1 Tel.: (855) 616-1818 (514) 637-1818 Fax: (514) 637-3985 E-mail: info@waterax.com Copyright © 2015 WATERAX Inc. Publication Number: 701237 Rev. 1 All rights reserved. Printed in Canada. 01/2015...

Table of Contents