Table of Contents
Advertisement
9
This cooker has class "2/1" overheating protection so that it can be installed next to
a cabinet.
If the cooker is installed adjacent to furniture which is higher than the gas hob cooktop, a
gap of at least 200 mm must be left between the side of the cooker and the furniture.
The furniture walls adjacent to
the cooker must be made of
material resistant to heat.
The veneered synthetical
material and the glue used
must be resistant to a temper-
ature of 90°C in order to avoid
ungluing or deformations.
The cooker may be located in
a kitchen, a kitchen/diner or
bed-sitting room but not in a
room containing a bath or
shower.
The appliance must not be
installed in a bed-sitting room
3
of less than 20 m
.
Curtains must not be fitted
immediately behind appliance
or within 500 mm of the sides.
It is essential that the cooker is
positioned as stated on fig.
9.1.
If the cooker is located on a
pedestal it is necessary to pro-
vide safety measures to pre-
vent falling out.
LEVELLING
The cooker is equipped with a 4
levelling feet which must be fitted
to the base of the cooker in the fol-
lowing manner:
• Place the cooker on its back as
shown in the figure 9.2.
• Screw the 4 levelling feet to the
cooker.
• Stand the cooker and levelling it
by screwing or unscrewing the
feet.
INSTALLATION
Fig. 9.1
Fig. 9.2
25
Advertisement
Table of Contents
