Subscribe to Our Youtube Channel
Related Manuals for Daikin RP200B7W1
Summary of Contents for Daikin RP200B7W1
- Page 1 INSTALLATION MANUAL Split System air conditioners Installation manual English Split System air conditioners RP200B7W1 RYP200B7W1 RP250B7W1 RYP250B7W1 R200F7W1 RY200F7W1 R250F7W1 RY250F7W1...
- Page 2 File Tecnico di Costruzione DAIKIN.TCF.004 / DAIKIN.TCF.016 e giudicato positivamente da KEMA secondo il Certificato 59277-KRQ/ECM95-4233 / 81728-KRQ/ECM98-4341. fi ˆ˜ ÚÔÛ‰ÈÔÚ›˙ÂÙ·È ÛÙÔ ∞Ú¯Â›Ô ∆¯ÓÈ΋˜ ∫ ·Ù·Û΢‹˜ DAIKIN.TCF.004 / DAIKIN.TCF.016 Î·È ÎÚ›ÓÂÙ·È ıÂÙÈο · fi ÙÔ KEMA Û‡Ìʈӷ Ì ÙÔ ¶ÈÛÙÔ ÔÈËÙÈÎfi 59277-KRQ/ECM95-4233 / 81728-KRQ/ECM98-4341.
- Page 4 R407C R407C 3N~50Hz 400V L1 L2 L3 N l ll lll...
-
Page 5: Before Installation
The units are packed in a wooden crate and attached on a DAMAGE TO THE EQUIPMENT. BE SURE ONLY TO USE wooden pallet. ACCESSORIES MADE BY DAIKIN WHICH ARE SPECIFIC- At delivery, the package should be checked and any damage ALLY DESIGNED FOR USE WITH THE EQUIPMENT AND should be reported immediately to the carrier claims agent. -
Page 6: Selecting Installation Site
ELECTING INSTALLATION SITE RECAUTIONS ON INSTALLATION 1. Select an installation site where the following conditions are • Check the strength and level of the installation ground so that satisfied and that meets with your customer’s approval. the unit will not cause any operating vibration or noise after •... -
Page 7: Refrigerant Pipe Size And Allowable Pipe Length
EFRIGERANT PIPE SIZE AND ALLOWABLE PIPE LENGTH RECAUTIONS ON REFRIGERANT PIPING When a heat pump outdoor unit is installed below the indoor unit, the following can occur: All field piping must be installed by a licensed refrigeration technician and must comply with relevant local and - when the unit stops, oil will return to the discharge side of the national regulations. -
Page 8: Precautions For Connecting Pipes
Remarks: Precautions for connecting pipes Front connection: When the outdoor unit is installed above the indoor unit the • Make sure to close the piping intake hole again after following can occur: installation work. 1. The condensated water on the stop valve can move to the Bottom Connection: indoor unit. -
Page 9: Charging Refrigerant
VACUATING HARGING REFRIGERANT The units were checked for leaks by the manufacturer. This unit requires additional charging of refrigerant according to the length of pipe connected at the site. Concerning R407C The refrigerant lines fitted in site are to be checked for leaks by refrigerant: charge the refrigerant to the liquid pipe in its liquid the fitter. -
Page 10: Complete Charging Of The Refrigerant
2. Complete charging of the refrigerant LECTRICAL WIRING WORK When the entire refrigerant pipe length is within 30 meters (for • All wiring must be performed by an authorized electrician. R407C) and 7.5 meters (for R22), charge the refrigerant in •... -
Page 11: Test Operation
EST OPERATION For the test run procedure, refer to the indoor unit installation manual. ISPOSAL REQUIREMENTS Dismantling of the unit, treatment of the refrigerant, oil and eventual other parts, should be done in accordance with the relevant local and national regulations. IRING DIAGRAM :FIELD WIRING :LIVE... - Page 12 4PW10932-1A Zandvoordestraat 300, B-8400 Oostende, Belgium...
Need help?
Do you have a question about the RP200B7W1 and is the answer not in the manual?
Questions and answers