Currys Essentials CID60W12 Instruction Manual page 11

INSTALLATION
16. Cut out a 600 mm wide slot from the plinth so
the unit door can fully open downwards. The
depth of the cut out should be sufficient to
allow the door to open fully and will depend
on the thickness of the panel fitted to the
door.
17. Make sure your plumbing is suitable for use
with the dishwasher. If in doubt contact
a qualified plumber. This unit MUST BE
connected to COLD WATER MAINS using the
new water supply hose. OLD HOSE SETS MUST
NOT BE RE-USED. The water pressure from the
water mains needs to be at a minimum of 0.04
MPa and a maximum of 1.00MPa.
• Connect one end of the water supply hose
to your dishwasher, and then connect the
other end of the hose to your water mains.
Please ensure the black rubber seal is in
place.
• After connecting the hose, turn on your
water mains and check for leaks.
• Connect the dishwasher to the mains
socket.
You may use a Y-adaptor (not included)
for an additional water feed for another
appliance, for example a washing
machine. This is only applicable for cold
water mains. A Y-adaptor is available from
most DIY stores.
• Do not bend or kink your drain hose.
* All images are for indication only; please refer to your individual unit for actual item.
water mains
Y-Adaptor
(not included)
Connect
to another
appliance
if required.
safety water supply hose
11