Electrical Parts List - Sony RMT-D254A Service Manual

7-2 ELECTRICAL PARTS LIST

NOTE:
• Due to standardization, replacements in the
parts list may be different from the parts
specified in the diagrams or the components
used on the set.
• -XX, and -X mean standardized parts, so they
may have some difference from the original one.
• RESISTORS
All resistors are in ohms.
METAL: metal-film resistor
METAL OXIDE: Metal Oxide-film resistor
F: nonflammable
• Not all of the parts are listed.
Ref. No. Part No. Description
9-885-120-55 ASSY PWB-FRONT AV SUB
**********************
< BEAD >
FABD1 9-885-083-84 BEAD-SMD 47ohm
FABD2 9-885-083-84 BEAD-SMD 47ohm
FABD3 9-885-083-84 BEAD-SMD 47ohm
FABD4 9-885-083-84 BEAD-SMD 47ohm
FABD6 9-885-083-84 BEAD-SMD 47ohm
FABD7 9-885-083-84 BEAD-SMD 47ohm
FABD8 9-885-083-84 BEAD-SMD 47ohm
FABD9 1-400-316-11 CORE-FERRITE BEAD 220ohm
< JACK >
FAJK1 9-885-111-45 JACK IEEE1394 4P/1 (DV IN)
USJK1 9-885-120-56 JACK USB 4P/1C, AU, WHITE
< DIODE >
* FAZ6 9-885-102-51 DIODE CDS3C30GTH
* FAZ7 9-885-102-51 DIODE CDS3C30GTH
* FAZ8 9-885-102-51 DIODE CDS3C30GTH
FAZ9 9-885-070-22 DIODE UDZ9
< SWITCH >
SW1 9-885-111-48 SWITCH-TACT (POWER)
SW2 9-885-111-48 SWITCH-TACT (ONE TOUCH DUB)
9-885-120-44 ASSY PWB-FTIMER VFD
*******************
< FLAT CABLE >
CN702A 9-885-120-45 CABLE-FLAT 85MM, 14P, 1.25MM
< DIODE >
D701 9-885-070-12 DIODE 1N4148
D702 9-885-070-12 DIODE 1N4148
D703 9-885-070-12 DIODE 1N4148
D704 9-885-070-12 DIODE 1N4148
D705 9-885-070-12 DIODE 1N4148
D706 9-885-070-12 DIODE 1N4148
D707 9-885-070-12 DIODE 1N4148
FRONT AV SUB
• Items marked "*" are not stocked since they are
seldom required for routine service. Some delay
should be anticipated when ordering these items.
• SEMICONDUCTORS
In each case, u: µ, for example:
uA...: µA... , uPA... , µPA... ,
uPB... , µPB... , uPC... , µPC... ,
uPD..., µPD...
• CAPACITORS:
uF: µF
• COILS
uH: µH
Remarks Ref. No.
DT701
RM701 9-885-069-95 MODULE REMOCON TSOP2240RF1
SW702 9-885-069-77 SWITCH-TACT (CH-DOWN)
SW703 9-885-069-77 SWITCH-TACT (PAUSE)
SW704 9-885-069-77 SWITCH-TACT (CH-UP)
SW707 9-885-069-77 SWITCH-TACT (PLAY)
SW712 9-885-069-77 SWITCH-TACT (REC)
SW713 9-885-069-77 SWITCH-TACT (FF)
SW714 9-885-069-77 SWITCH-TACT (OPEN/CLOSE)
SW715 9-885-069-77 SWITCH-TACT (REW)
(USB CONNECTOR) SW716 9-885-069-77 SWITCH-TACT (STOP)
9
AVIC1
DIC1
DIC2
9 HIC1
MIC2
Note 1: Special key has been written in the HIC1 (HDCP key)
Note 2: Perform the reset whenever the MIC3 was replaced.
MIC3
TIC1
AVR02
AVR03
AVR19
AVR40
HB1
HB2
7-3
FTIMER VFD
When indicating parts by reference number,
please include the board name.
The components identified by mark 0 or
dotted line with mark 0 are critical for safety.
Replace only with part number specified.
The components identified by mark 9
contain confidential information.
Strictly follow the instructions whenever the
components are repaired and/or replaced.
Part No. Description
< VFD DISPLAY >
9-885-120-46 VFD DISPLAY VFD20-1022, 10G
< REMOCON MODULE >
< SWITCH >
9-885-120-57 ASSY PWB-MAIN
**************
< IC >
9-885-111-37 IC SAA7138HL (VIDEO DECODER)
9-885-111-38 IC K4H561638 (DRAM)
9-885-111-38 IC K4H561638 (DRAM)
IC (VIDEO PROCESS) (Refer to Note 1)
IC (CPRM Key) (Refer to Note 1)
and MIC2 (CPRM key), therefore the HIC1 and MIC2 can-
not be replaced.
If these IC are faulty, replace the board entirely.
9-885-120-60 IC (FLASH) (Refer to Note 2)
9-885-070-64 IC TSB41AB1-PAP (DATA COMM/GEN)
< FERRITE BEAD >
1-400-316-11 CORE-FERRITE BEAD 220ohm
1-400-316-11 CORE-FERRITE BEAD 220ohm
1-400-316-11 CORE-FERRITE BEAD 220ohm
1-400-316-11 CORE-FERRITE BEAD 220ohm
9-885-083-84 BEAD-SMD 47ohm
1-400-316-11 CORE-FERRITE BEAD 220ohm
MAIN
Remarks