Panasonic NC-ZA1 Operating Instructions Manual page 21

6
Press
(e.g.: When cappuccino is selected)
Time bar is increasing according to process.
Wait until display shows
to remove the cup(s).
(simple rinsing)
7
Fill a glass with clean water and press
• This cleaning cycle is for next drink preparation without milk residue.
• Switch the milk hose from milk package to the glass and set the empty cup under the dispenser. (Cup size > 250 mL)
The display will return to the main menu
when the rinsing cycle is completed.
Q To turn off the power after use « P. EN25
to start brewing.
Note
• Be careful with steam coming out after
is pressed.
• If is pressed during the brewing process, it immediately
stops the process.
After flashes, the display will move on to step 7.
• If the temperature of the water is not sufficient to brew coffee, the
heating up process will be performed first.
• When brewing cappuccino or Latte Macchiato, the display shows as
follows.
Between brewing milk and coffee, brewing will
be paused.
• If surface of milk is higher than the spouts position, it may cause milk
to drip from the dispenser. In that case, pull up the dispenser to the
highest position. If it does not stop, pull the hose out from the milk
package and re-insert.
to start rinsing.
Note
• If you prepare milk menu continuously, skip this cycle by pressing
.
• If is pressed during the rinsing cycle, it immediately stops
the process.
After flashes, the display will return to the previous display.
EN21