Yamaha R-S700 Owner's Manual page 40

Hide thumbs Also See for R-S700:
Table of Contents

Advertisement

Available languages

Available languages

TROUBLESHOOTING
Problem
The desired
frequency
cannot be
tuned in.
FM/
NO PRESETS
AM
is displayed.
WRONG
STATION is
displayed.
The desired
station cannot
be tuned in
with the
automatic
tuning method.
Automatic
station preset
AM
does not work.
There are
continuous
crackling and
hissing noises.
There are
buzzing and
whining noises.
■ iPhone/iPod
The following messages may be displayed on the front panel display in certain situations.
Message
Connect error
Unknown iPod
Connected
Disconnected
38
En
Cause
Incorrect setting for the tuning step.
No preset stations are registered.
An invalid FM/AM frequency has been
input.
The signal is weak or the antenna
connections are loose.
Automatic station preset is not available
for AM stations.
The noises may result from lightning,
fluorescent lamps, motors, thermostats or
other electrical equipment.
A TV set is being used nearby.
Status/Cause
There is a problem with the signal path
from your iPhone/iPod to the unit.
The iPhone/iPod being used is not
supported by the unit.
Your iPhone/iPod is properly placed in
the Universal Dock for iPod.
Your iPhone/iPod is properly placed in
the Wireless System for iPod and
connected with this unit via wireless
transmission.
Your iPhone/iPod is removed from the
Universal Dock for iPod.
Your iPhone/iPod is disconnected with
this unit via wireless transmission.
The wireless connection is poor.
Remedy
Set the tuning step properly according to your area.
Register stations you want to listen to as preset
stations before operation.
Input a frequency that can be received.
Tighten the AM loop antenna connections and orient
it for the best reception.
Try using the manual tuning method.
Use manual station preset.
Try using an outdoor antenna and a earth ground.
This will help somewhat, but it is difficult to
eliminate all noise.
Move this unit away from the TV set.
Remedy
Turn off the unit and reconnect the Universal Dock
for iPod to the DOCK jack of the unit.
Remove your iPhone/iPod from the Universal Dock
for iPod and then place it back in the dock.
Connect an iPhone/iPod supported by the unit.
Place the YID-W10 receiver as far away from this
unit as possible.
See
page
31
20
19
19
21
See
page
24
24
24
26
24

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

R-s500

Table of Contents