Kenwood z838w Manual page 46

Installation
■ Removing the hard rubber frame
1
Engage the catch pins on the removal tool and remove the two
locks on the lower level.
Lower the frame and pull it forward as shown in the figure.
Accessory2 Removal tool
2
When the lower level is removed, remove the upper two
locations.
The frame can be removed from the top side in the same manner.
■ Removing the Unit
1
Refer to the section "Removing the hard rubber frame" and then
remove the hard rubber frame.
2
Remove the screw (M4×8) on the back panel.
3
Insert the two removal tools deeply into the slots on each side,
as shown.
Catch
Lock
Screw (M4X8)
(commercially
available)
4
Lower the removal tool
toward the bottom, and pull
out the unit halfway while
pressing towards the inside.
Be careful to avoid injury from the catch pins on the removal tool.
5
Pull the unit all the way out
with your hands, being
careful not to drop it.
— 47 — — 47 —
Accessory2 Removal tool