THUNDER TIGER Cloud Dancer 60 ARF Assembly Manual page 9

RETRACT INSTALLATION
Bend the pushrods for proper clearance and connect to servo arm
with "Z" bend or " EZ contnects". Install the wheels and check for
proper operation.
IV.Wing Bolts
Measure the top and bottom to find center of the Wing Protector.
This will be used to center the protector on the trailing edge of the
wing panel. Place the protector on the wing panel and mark around
the three sides with a pen or marker. Remove the protector and then
remove the covering material inside the lines. Be careful not to push
through the balsa; remove only the covering.
Apply a liberal amount of medium CA to the exposed wing panel
and place the Wing Protector on it, holding it until the CA sets.
Sharp the Wing Bolts as shown.
Screw the Wing Bolts inversely so the sharp ends just a little higher
than the saddle of fuselage.
Be careful install the main wing on the fuselage and not to touch
the sharp end of wing bolts. Push it to mark the points on the wing
when wing is aligned.You can see the two points at the trailing edge
of wing panel.
Drill 6mm(1/4") holes at the points. Note:The bit should be about
75-degree angled to the wing surface when you are drilling the hole.
Strips of covering film are provided to trim out the center joint. You
will need to use a covering iron or a household iron to secure the
film.
9