THUNDER TIGER Cloud Dancer 60 ARF Assembly Manual page 8

Cut away the balsa sheeting to expose the retract servo location.
Glue the retract servo mount and wing dowel in place as shown.
Use the template and mark where the retract goes.
Remove the covering material that covers the landing gear hole in
the bottom of the wing. Next cut away the sheeting to accommodate
the plastic wheel well.
Trim the plastic wheel wells as shown.
RETRACT INSTALLATION
Glue the wheel wells into the wing using a compatible glue such
as "Zap-a-dap-a-goo", RC 56, or "Shoe-Goo ". Drill pilot holes for the
retract assemblies.
Attach pushrod with metal clevis to the retract assembly, move it
into position.
Let the other end of pushrod goes out the opening then secure the
retract to the hardwood blocks.
Mount the retract servo in place as shown.
8