Charging And Attaching The Battery - Motorola iDEN User Manual

Charging and Attaching the Battery

Remove the battery from the protective case provided in the original
packaging. When the battery is not attached to the phone or being
charged, store it in this case.
Charging the Battery
N O T E
Attach the charger connector to the i2000 phone, then ßip open the
prongs and plug the charger into an electrical outlet. For more
information about chargers, see ÒTravel ChargerÓ on page 57,
ÒVehicular Battery ChargerÓ on page 58, and ÒDesktop Dual-Pocket
ChargerÓ on page 59.
Attaching the Battery
To attach the battery to your i2000
phone, align the battery as shown. Press
down on the battery until you hear a
click.
Battery and Charging Status
A low battery is indicated by a short,
chirp-like sound through the speaker.
The battery strength icon shows the
remaining charge in the battery. Three
bars indicate full charge. When you
have less than Þve minutes of talk time
remaining, the indicator ßashes.
Charging
Discharging
Detaching the Battery
To detach the battery, press the latch to release the battery and pull out
the battery.
N O T E
Before you use the battery for the Þrst time, charge it
for at least three hours.
Icon
Flashes
Low Battery
Low Battery
Figure 1. Battery Charging Status
Before removing the battery, make sure the phone is
turned Off.
0-30% 31-60%
0-10% 11-40%
Getting Started
Latch
61-90% 91-100%
41-70% 71-100%