Tips - GE egr3000 Owner's Manual & Installation Instructions

Before you call for service...
Troubleshooting Tips
Problem
"LOCK DOOR" flashes
in the display
LOCKED DOOR light
is on when you want
to cook
Oven door will not
unlock (on models
with a door latch)
"Door" appears in the
display (on models
with a door latch)
"F—and a number or
letter" flash in the display
Display goes blank
Display flashes
Unable to get the
display to show "SF"
Power outage,
clock flashes
Oven shelves are
difficult to slide
46
Possible Causes
The self-clean cycle has been
selected but the door is not
closed.
The oven door is locked
because the temperature
inside the oven has not
dropped below the
locking temperature.
Oven is too hot.
Self-cleaning cycle has been
selected but the latch handle
was not moved all the way
to the right.
Latch handle was moved to the
right but a program other than
self-cleaning was selected.
On models with a door latch,
if a function error code appears
during the self-cleaning cycle,
check the oven door latch.
You have a function error code.
If the function code repeats.
A fuse in your home may be
blown or the circuit
breaker tripped.
The clock is in the
black-out mode.
Power failure.
Oven control pads were
not touched properly.
Power outage or surge.
The nickel shelves (if so equipped) • Apply a small amount of vegetable oil to a paper
were cleaned in a self-clean cycle.
The gray porcelain-coated shelves
(if so equipped) were improperly
cleaned.
What To Do
• Close the oven door.
• Touch the CLEAR/OFF pad. Allow the oven to cool and
then, on models with a door latch, unlock the door.
• Allow the oven to cool below locking temperature.
Do not lock the door with the door latch except when
using the self-clean feature.
• Move the latch handle all the way to the right.
• Move the latch handle to the right only when setting
the self-cleaning cycle.
• The latch may have been moved, even if only slightly,
from the locked position. Make sure the latch is moved
to the right as far as it will go.
• Touch the CLEAR/OFF pad. Allow the oven to cool for
one hour. Put the oven back into operation.
• Disconnect all power to the range for 5 minutes
and then reconnect power. If the function error
code repeats, call for service.
• Replace the fuse or reset the circuit breaker.
• See the Special features of your oven control section.
• Reset the clock.
• The BAKE and BROIL HI/LO pads must be touched at
the same time and held for 3 seconds.
• Reset the clock. If the oven was in use, you must reset
it by touching the CLEAR/OFF pad, setting the clock and
resetting any cooking function.
towel and wipe the edges of the oven shelves with
the paper towel. Do not spray with Pam
lubricant sprays.
® or other