Rear Panel - Bugera 1990 User Manual

6
BUGERA 1990 User Manual
(15) (16) (17) (18) (19) (20)
Rear panel of the BUGERA 1960

Rear panel

! !
CAUTION!
Hot! Risk of injury! During use, the valves get very hot and high surface
temperatures may be reached at the rear of this unit. Avoid touching
the controls and connectors on the rear panel during use. To avoid
accidental contact with hot surfaces, place the rear panel so that it
faces a wall.
(15) The FOOTSW(itch) jack is used to connect to the provided footswitch.
Please make sure that a cable has been connected before turning on the
amplifier. For more information, read Chapter "Footswitch."
(16) The LEVEL rotary knob adjusts the output level of the signal sent to an
external effects unit or any other signal processor (0 – 10). Turning the knob
to the right increases the signal level, whereas turning it to the left decreases
the signal level. In order to produce sound with the least possible noise,
we suggest using a high setting without distorting the signal.
(17) The SEND output is used to connect a shielded 1/4" mono jack cable to the
input of an external effects unit.
(18) The RETURN input is used to connect a shielded 1/4" mono jack cable to the
output of an external effects unit.
(19) The RECORDING output is used to connect directly to a recording device or
a PA system. This signal is specially filtered to provide the optimum signal
quality for this application.
(20) The DIRECT output is used to route the amplifier's unfiltered preamp signal,
for example, to a second amplifier and loudspeaker system by retaining the
original sound.
(21) The IMPEDANCE switch lets you specify the loudspeaker impedance.
Always apply the value that is identical to the impedance of the used
speaker cabinet. Please also read "Wiring the BUGERA".
! !
(22) Both the paralleled LOUDSPEAKER outputs (1/4" mono jacks) are used
to connect the speaker cabinet(s). The minimum impedance is 4 Ohms.
The IMPEDANCE switch should always be set to match the impedance of the
used speaker cabinet.
bugera-amps.com
(21) (22) (23)
! !
ATTENTION!
TO AVOID DAMAGE TO YOUR AMP, NEVER USE THE BUGERA VALVE
AMPLIFIER WITHOUT A LOUDSPEAKER CONNECTED!
! !
(23) This POWER switch reduces the output power of the amplifier. In 50 W
mode, the amplifier switches to triode operation, reducing the output power
by half (from 100 W to approx. 50 W). In 100 W mode, the amplifier runs at
full power in pentode operation (100 W).
*!
(24) WARNING: ONLY REPLACE THE FUSE WHEN THE MAINS CABLE HAS BEEN
DISCONNECTED! The FUSE is found in the fuse holder. If the fuse is
blown, it needs to be replaced with a fuse of the same kind by all means.
Otherwise, the unit could seriously be damaged, in which case the warranty
is void. If the fuse is blown repeatedly, you should take the unit to a qualified
service technician.
*!
(25) The IEC MAINS connector is used to connect the mains cable that has
the appropriate voltage ratings for your country (included). At all times,
make the connections to the amplifier before plugging the cable into a
power outlet.
(26) This is the SERIAL NUMBER of the amplifier.
(26)
(24) (25)