Scanning in Presentation Mode
The optional Intellistand adds greater flexibility to scanning operation. When you insert the digital imager scanner
into the stand's "cup," the scanner's built-in sensor places the scanner in presentation (hands-free) mode. When
you remove the digital imager scanner from the stand it operates in its normal hand-held mode.
Scanner
Holder (Cup)
Inserting the Digital Imager Scanner in the Intellistand
Figure 2-7
To operate the digital imager scanner in the IntelliStand:
Connect the digital imager scanner to the host (see the appropriate host chapter for information on host
1.
connections).
Insert the digital imager scanner in the Intellistand by placing the front of the digital imager scanner into the
2.
stand's "cup" (see
Use the Intellistand's adjustment knobs to adjust the height and angle of the digital imager scanner.
3.
Center the symbol in the aiming pattern. The entire symbol must be within the brackets.
4.
Upon successful decode, the digital imager scanner beeps and the LED turns green. For more information on
5.
beeper and LED definitions, see
Figure
2-7).
Table 2-1
and
Angle Adjustment Knob
Height Adjustment Knob
Table
2-2.
Scanning
2 - 7