Chapter 4 User Preferences & Miscellaneous Digital Imager Scanner Options; Introduction - Symbol DS6707 Product Reference Manual

Chapter 4 User Preferences & Miscellaneous
Digital Imager Scanner Options

Introduction

You can program the digital imager scanner to perform various functions, or activate different features. This
chapter describes each user preference feature and provides programming bar codes for selecting these features.
The digital imager scanner ships with the settings shown in
Default Parameters
programming is not necessary.
To set feature values, scan a single bar code or a short bar code sequence. The settings are stored in non-volatile
memory and are preserved even when you power down the digital imager scanner.
NOTE Most computer monitors allow scanning the bar codes directly on the screen. When scanning from the
screen, be sure to set the document magnification to a level where you can see the bar code clearly, and
bars and/or spaces are not merging.
If not using a USB cable, select a host type after the power-up beeps sound. See
7, USB Interface and
first power-up when connected to a new host.
To return all features to default values, scan the
bar code menus, asterisks (
for all host device and miscellaneous defaults). If the default values suit requirements,
Chapter 8, RS-232 Interface
*
) indicate default values.
*
Indicates Default
Table 4-1 on page 4-2
for specific host information. This is only necessary upon the
Set Default Parameter on page
*
High Volume
Feature/Option
(00h)
Option Hex Value for
programming via SSI
command
(also see Appendix A, Standard
Chapter 6, SSI Interface Chapter
4-4. Throughout the programming