Connecting An Rs-232 Interface - Symbol DS6707 Product Reference Manual

8 - 2 Symbol DS6707 Digital Imager Scanner Product Reference Guide

Connecting an RS-232 Interface

The digital imager scanner connects directly to the host computer.
Serial Port Connector to
RS-232 Direct Connection
Figure 8-1
NOTE Interface cables vary depending on configuration. The connectors illustrated in
only. The connectors may be different than those illustrated, but the steps to connect the scanner are the
same.
Connect the modular connector of the RS-232 interface cable to the cable interface port on the digital imager
1.
scanner (see Installing the Interface Cable on page
Connect the other end of the RS-232 interface cable to the serial port on the host.
2.
Connect the power supply to the serial connector end of the RS-232 interface cable. Plug the power supply
3.
into an appropriate outlet.
Select the RS-232 host type by scanning the appropriate bar code from
4.
To modify any other parameter options, scan the appropriate bar codes in this chapter.
5.
Host
Power Supply Cable
Interface Cable
1-3).
RS-232 Host Types on page
Figure 8-1 are examples
8-6.