Connecting Water Supply Hose - Kenmore 796.3152*21 Series Service Manual

2-2. CONNECTING WATER SUPPLY HOSE

Before connecting the Water Supply Hose to the water tap, check the hose type and then choose the
correct instruction here under.
Screw Type
1
Attach the water supply hose to the tap.
Push the water supply hose up so that the rubber packing
within the hose can adhere completely to the tap.
2
Connect the water supply hose to the tap.
Connect the water supply hose to the tap and then tighten it by
screwing it to the right.
3
Check water leakage. Check water leakage.
After connecting the hose, open the tap to check for After connecting the hose, open the tap to check for
any water leakage. any water leakage.
Connecting Water Supply Hose to the machine
• Connect the water supply hose to inlet valve of
the washing machine, and then lock it by turning
the hose connecting part.
• Check to see if there is a rubber seal inside the
connector.
• A new washing machine should be installed with new hoses.
The old hoses shuld not be reused.
Water tap
Water Hose
(to water inlet
on washer)
Rubber Seal
6
Rubber Seal
Water Supply Hose
Hot
Cold
Rubber Seal
Water Hose
(to tap)