Kenmore 796.3152*21 Series Service Manual page 28

Bearing Housing
⑨ Remove four screws to release the tub bracket.
⑩ Remove 17 screws to release the bearing housing.
Pull the housing away from the tub, but do not pry it
with a screwdriver to avoid damage.
9) Disassembly of Door Lock Switch
Remove the two door lock attachment screws.
①
Remove the door switch and remove the attachment tube.
②
10) Disassembly of Heater
① Remove the three heater attachment screws.
② Loosen the nut at the middle of the heater to relieve
the tension on the clamp. Then pull it out of the
case.
28