•
Loose locking screw.
•
Mount the device with the holder on the tripod.
•
Tighten locking screw.
6.2
Mount barndoors
•
Loose fastening screw.
•
Slide the barndoors into the lateral guide rail.
•
Tighten fastening screw.
6.3
Connect to power supply
• Switch off device.
See Switch the device on and off.
• Compare the local power supply with the connected load of the device.
See Technical specifications.
If the values differ, please contact info@foto-walser.de or tel. 49 84 32 / 9489-0.
• Connect the power cord with the socket on the device and with the power socket.
7.
Operation of the device
7.1
Adjust tilt angle
• Open tilt lever.
• Adjust the required tilt angle.
• Tighten tilt lever.
7.2
Switch the device on and off, dim it
• Switch the device on:
Press On/Off switch.
• The device is ready for operation.
• Turn the dimmer until the required light power is achieved.
• The LED light up.
• Switch off device:
Press On/Off switch.
• If the lamps were switched on:
The lamps go out.
8.
Transportation and storage
• Switch off device.
See Switch the device on and off.
• Let the device cool down completely.
WARNING! Danger of burning through hot parts. Let the device cool down completely.
• Cover the LED with e.g. bubble wrap and demount the barndoors.
• Unplug the power cord and power supply unit.
Guide Rail
8
Holder with Fastening
Screw