Table of Contents
Advertisement
WARNING
Danger of electric shock, fire through short-circuit
A short-circuit could be caused through defect cables and through humidity or moisture. A short-
circuit can warm up the conductors, so that there isolation will melt or even melt thoroughly. This
could lead to fire.
− Please just use the original cables, which are included in delivery. They are aligned for your
device and guarantee the necessary safety for you and your device.
− Don´t operate the device with wet hand or feet.
− Operate the device only in dry rooms.
− Don´t operate the device outdoors.
− Please only follow this instruction manual for cleaning the device.
− Make sure, that cables and conductors won´t be damaged. Damages could be caused through
heat impact, chemical influence or through mechanical impacts as rubbing, bending, tearing,
rolling over or nibbling animals.
− Prevent your device for falling-off.
In case of falling-off, please let an electrician check the device before switching on again.
− If your device should be damaged or defect or if you notice a burning smell:
Disconnect the power supply by pulling out the power cord immediately. Never operate your
device with damaged housing, defect lamps or damaged power cord. Don´t open the device.
Never repair the device on your own. The device should only be repaired by electricians.
− Please follow this instruction manual for maintaining your device.
− Please just use spare parts, which are conform to the required specifications.
See Technical Specifications.
WARNING
The device can overheat, if you operate it with covered ventilation slots.
The device itself, accessories and easily inflammable materials in close distance could catch fire. The
accessories can overheat, if it does not comply with the necessary specifications.
− Don´t cover the ventilation slots of the device during operation.
− Please just use accessories and spare parts, which are conform to the required specifications.
See Technical Specifications.
− Remove easily inflammable materials, which are in close distance to the device.
CAUTION
Danger of burning on hot parts
The lamps could heat up up to 40°C.
− Don´t touch the parts during operation and cooling down.
− Please cool down your device completely before starting any mounting or maintenance
arrangements.
WARNING
Danger of cutting and splitting through breaking lamps,
possible discolouration on the lamps
Lamps can break and split, when they fall down.
Even small residues of skin oil on the lamps could lead, due to the high heat impact, to the splitting
of the lamp. Broken glass could hurt eyes and skin.
− Please handle the lamps with care to avoid bursting.
5
Advertisement
Table of Contents
