Table of Contents
Advertisement
STEP 7 (See Diagram 7)
A.) Load 25 lbs two Weight Plates (#26) onto each end of the Bar.
B.) Load 15 lbs two Weight Plates (#27) onto each end of the Bar.
C.) Attach a Spring Clip (#19) to each end of the Bar to hold the plates in position.
D.) Place the Weight Bar (#14) onto the Left & Right Upright Beam (#2) & (#1).
E.) When unloading weight plates. Weight plates on the Bar must be taken off in equal
amounts at the same time to prevent the bar being unevenly weighted which will
cause the Bar to tip. It is strongly recommended always move the Bar from Uprights
to ground when loading and unloading Weight Plates.
11
DIAGRAM 7
Advertisement
Table of Contents
