Table of Contents
Advertisement
PRE-RIDE CHECKLIST
Loose Parts
Check and secure all fasteners before every ride. Make sure the
collar clamp, quick release lever, and handlebar spring buttons
are locked properly in place before riding.
Replacement Parts
Replace worn or broken parts immediately.
Call 1-866-467-2967 for parts or visit shop.razor.com.
Safety Gear
Always wear proper protective equipment, such as an approved
safety helmet, elbow pads and kneepads. Always wear shoes
(lace-up with rubber soles) and keep shoelaces tied and out of
the way of the wheels. Never ride barefooted or in sandals.
USAGE
How to Ride
Place one foot on the baseboard, push forward with the other foot. Steer with both hands on the handlebars. For
enhanced cornering, lean slightly into the direction of the turn.
How to Stop
For controlled stops, apply the brake by placing the heel of the foot on the brake. Razor recommends that you
practice applying the brake at various speeds and in an open area free from obstructions before riding your Razor
scooter around others.
Need Help? Visit our web site for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer Service
contact information is listed at the back of this manual.
Spark_Series_MAN_US_141117.indd 5
Be Careful!
You will see people on TV and maybe even people you know doing
tricks and stunts. These are people who have been practicing on
scooters for a very long time. Don't try something until you are
ready. Avoid steep inclines and don't ride too fast — you can lose
control and fall. Skateboard parks are not designed for scooters.
Never ride in traffi c or on the street and watch your surroundings
for pedestrians, skaters, skate boards, electric products, bikes,
children or animals who may enter your path and respect
the rights and property of others.
Maintain a hold on the handlebars at all times.
To activate the sparks place ball of foot on the Spark
Bar and gradually apply pressure while riding. Only
use enough pressure to cause sparking action.
Note:
• LED deck lights apply to Spark 2.0 only.
• Lighted wheels light up when wheels are in motion.
(Spark 2.0, Spark DLX, and Spark
only)
+
5
WARNING: Applying too
much pressure on the Spark Bar
may cause loss of control.
NOTE: Using any other part of
the foot or full foot may activate the
brake and prevent sparking action.
NOTE: Sparks and Spark
Cartridge life will vary based
on the amount of pressure
applied to the Spark Bar,
the length of time pressure is
applied and the smoothness
of the riding surface.
11/17/14 6:23 PM
Advertisement
Table of Contents
