Table of Contents
Advertisement
Backlight
In low-light conditions, the pager's backlight automatically turns on
whenever a button is pressed. You can manually turn the backlight on or off
at any time by pressing and holding
automatically turns off when the pager returns to the Standby screen.
Receiving/Reading Personal Messages
Your pager can receive up to 19 personal messages. When a message is
received, your pager alerts according to the current alert setting (audible,
vibrate, or no message alert). A new message is indicated by a flashing
symbol. When a message is selected the symbol changes to o.
Reading an Incoming Message
Press any button to stop the alert.
J
Press
to display your message.
A flashing t in the right corner of the screen indicates the message is
continued on an additional screen(s).
J
Press
to read the next screen.
Message Preview
This feature allows you to scan the first line of your messages.
J
Press
.
Use the H and I buttons to move the cursor through your
messages.
Note: Previewing an unread message does not remove the unread
message status from the message.
Display Zoom
When this feature is enabled, the standard 4-line display is converted to a
2-line display. The characters are enlarged vertically, increasing message
readability.
To Enable Display Zoom:
From the Function menu, press H to move the cursor to 1.
K
Press
. Display zoom is now active.
All new and stored messages including notebook messages are displayed
in a 2-line format. Pager prompts are not enlarged in the zoom mode.
K
for two seconds. The backlight
m
Reading a Stored Message
From the Message-status screen press H or I to move the cursor to
the message you want to read.
J
Press
to read the message.
Message Reading Features
• Press G to read a message line by line.
• Press and hold
• Press F to go back to the first screen of the message.
• Press H or I while reading a message to read the previous or next
message.
Note: When an unread message exists, your pager gives a periodic
reminder alert until all unread messages are read, or for up to 30 minutes.
A flashing N on the Standby screen indicates that you have unread
messages.
7
8
To Disable Display Zoom
From the Function menu, press H to move the cursor to 4.
K
Press
. Display zoom is now disabled.
Setting the Time and Date
From the Function menu, press H to move the cursor to v.
K
Press
to display the Set-time-and-alarm screen.
Press I to move the cursor to the hour digit.
Press F or G to adjust the hour.
Repeat steps 3 and 4 to adjust the minutes, AM/PM/24 hr., month, day,
and year.
10
9
J
for automatic message scrolling, screen by screen.
Advertisement
Table of Contents
