Siemens Extraklasse 1300 Instruction Manual And Installation Instructions page 35

Table of Contents

Advertisement

Fault
Programme does not
start.
The Ready" indicator
flashes.
Programme does not
start.
Water does enter the
machine or detergent is
hi
d t
not washed away.
not washed away.
The Wash" indicator
flashes.
Detergent in chamber I is
not washed away.
Water cannot be seen in
drum.
Washing solution is not
g
completely drained.
l
l d i d
The Rinse" indicator
light flashes.
Water is flowing out from
underneath the machine.
Foam coming out of the
detergent dispenser.
The laundry was not
spun.
Cause
Loading door not closed properly.
Start" button not pressed.
Water tap not turned on.
t i
Supply hose kinked or trapped.
Strainer in supply hose clogged.
A programme without Prewash was
selected.
This is not a fault.
The water lies below the visible part of the drum.
Loose debris is blocking the pump.
Fluff producing laundry was
washed. The water drainage pipe
or drain hose is blocked.
The thread of the supply hose is not
tight.
Leak in the drain hose.
To much detergent.
Large items of clothing became
entangled and could not be
distributed evenly in the drum.
For safety reasons, the high speed
final spin cycle was automatically
cancelled.
Action
Check whether laundry is trapped
in door.
Close the loading door (a click
should be heard).
Press the Start" button.
Turn on water tap.
Clean the strainer; see from
Page 33.
Select 60 C Cottons / Coloureds
with prewash".
Clean the pump (refer to page 31).
Clean the water drainage pipe
and/or drain hose.
Tighten the thread.
Replace the drain hose.
Mix 1 tablespoon of fabric softener
with ½ litre / 1 pt of water and pour
into chamber II of the detergent
dispenser.
Reduce the amount of detergent
next time.
Always load large and small items
together into the drum (see also
imbalance compensation system).
35

Advertisement

Table of Contents
loading

Table of Contents