Siemens Extraklasse 1300 Instruction Manual And Installation Instructions page 21

Finish In / Delay
Start" display and
Delay Start" button
Finish In" display
q Turn the programme selector to the desired
programme.
The Ready" indicator light is on.
The expected Finish In" time (programme
duration) is displayed, e.g. 1:58".
i The Finish In" time is displayed in hours and
minutes, e.g.
1:58 - 1 hour and 58 minutes
0:55 - 55 minutes.
After the programme starts, the Finish In" time is
counted down by minutes.
When the programme ends, the displays shows 0".
i At the start of the programme, a projection of the
Finish In" time occurs under the assumption of a
full load and a water supply temperature of 15 C.
The actual load will be determined within the first
10 minutes.
The Finish In" time can become increased or
reduced while the programme is running for the
following reasons.
Reductions in time occur because of:
- Small loads.
Increases in time occur because of:
- An additional rinse cycle if excessive foam is in the
laundry,
- Multiple spinning if the laundry is distributed poorly
in the drum,
- Increased heating times, e.g. when the water is
too cold,
- Water pressure too low,
- Very absorbent laundry.
21