Operation Of Current Device - RCA RACE1202-B Owner's Manual

SAFETY PRECAUTIONS
Provide occasional ventilation during use. Do not direct aif flow at fireplaces or other heat related sources as this could
cause flare ups or make units run excessively.
Do not climb on or place objects on outdoor part of the unit.
Do not hang objects off the unit.
Do not place containers with liquids on the unit.
Turn off the air conditioner at the power source when it will not be used for an extended period of time.
Periodically check the condition of the units installation accessories for any damage.
Do not apply heavy pressure to the radiator fins of the unit.
Operate the unit with air filter in place.
Do not block or cover the intake grille, discharge area and outlet ports.
Ensure that any electrical/electronic equipment is one yard away from the unit.
Do not use or store flammable gases near the unit.
READ THIS SECTION BEFORE ATTEMMPTING TO OPERATE AIR CONDITIONER.
Unit must be upright for one hour prior to operating.

Operation of Current Device

Plug in
& press RESET
Remark: The apperance of actual plug
may be slightly different from the line
drawing shown in the figure. The line
drawing is for reference only.
DANGER! Avoid Injury or damage to the unit or other property
TEST POWER
RESET
Important Safety Instructions
The power supply cord contains a current device that senses
damage to the power cord. To test your power supply cord do the
following:
1. Plug in the Air Conditioner.
2. The power supply cord will have TWO buttons on the plug side.
Press the TEST button. You will notice a click as the RESET button
pops out.
3. Press the RESET button. Again you wil notice a click as the
button engages.
4. The power supply cord is now supplying electricity to the unit.
NOTE:
Do not use this device to turn the uinit on or off.
Always make sure the RESET button is pushed in for correct
operation.
The power supply cord must be replaced if it fails to reset
when either the TEST button is pushed, or it cannnot be
reset. A new one can be obtained from the product
manufacturer.
If power supply cord is damaged, it CANNOT be repaired. It
must be replaced by one obtained from the product
manufacturer.
3