RCA RACE1202-B Owner's Manual page 18

Installation
B: For Vinyl-Clad windows:
Drive (ST4X16FT) locking screws through the frame and into the window sash (FIG.8B).
NOTE: Before driving the screws, use a drill to drill 5 holes through the holes in the frame and
frame extensions into the window sash as shown (FIG.8B).
FIG.8A
7 After the completion of the installation, please check the machines lean as shown
(FIG.10A & FIG.10B).Its necessary for proper condensed water utilization and drainage.
FIG.10A
H
INSIDE
H
about
1/4"-1/2"
Wooden Windows
8
Trim the weather seal with a proper length, peel off
the protective backing and plug any
gas if needed as shown FIG.13.
Remove the air conditioner From Window
Turn the air conditioner off, and disconnect power cord.
*
*
Remove sash seal from between windows.
Remove screws installed through frame and the sash.
Close (slide) curtains into frame.
*
Keeping a firm grip on air conditioner, raise sash and
*
carefully remve.
Be carefully not to spill any condensate water while
*
lifting unit from window. Store parts WITH air
conditoner.
OUTSIDE
Bottom Rail
FIG.8B
FIG.10B
H
INSIDE
H= H1- H2
about 1/4"-1/2"
H2
H1
Vinyl-clad Windows
OUTSIDE
Bottom Rail
FIG.13
17