Operating Instructions; Cleaning And Maintenance - Sunbeam SWM6008-CN Instruction Leaflet

F E AT U R E S - O P E R AT I O N S
C L E A N I N G / M A I N T E N A N C E
6. Plug the humidifier into a 120V electrical outlet.

OPERATING INSTRUCTIONS

1. Fill the water tank.
2. Turn the power knob to the HIGH (2) position. The
power light will be ON and the Reset Light will be off.
It is normal for the humidifier to take about 10
minutes to warm up and begin to mist.
3. After the unit begins misting, set the humidifier to the
desired power setting (2 or 1).
Figure 1
H
G
Off
Reset
Low
High
F
E
D
A. Carry Handle
B. Humidifier Tank
C. Humidifier Base
D. Removable Tray
E. Heating Element
A
B
C
F. 2-Speed Humidity
Control/Power Knob
G. Humidifier Housing
H. Vent
RESET PROCEDURE
NOTE: When the water tank is empty and the water in
the Heating Chamber is almost empty, the Automatic Shut
off will activate. The RESET Light will illuminate and the
unit will not operate again until you refill the water tank
and reset the humidifier.
1. Turn the power knob to RESET ( ).
2. Unplug the unit.
3. Remove and refill the water tank, being sure to
follow the Daily Maintenance Instructions. Replace the
tank onto the base.
4. Wait 15 minutes for the Automatic Shut-Off to reset.
5. After the 15 minutes, plug in the unit and turn the
Power Knob, to HIGH. The RESET light should now be
off (if not repeat steps 1-5). In about 10 minutes, the
humidifier will begin to produce moisture.
If the reset light is still on at this point, and the unit does
not begin to produce moisture within a few minutes, then
repeat Steps 1-5.
IMPORTANT: If you do not plan to use the humidifier
for two or more days, make sure any residual water is
drained from the water tank and base to prevent algae
or bacteria growth.

CLEANING AND MAINTENANCE

INSTRUCTIONS
The following maintenance procedures must be
routinely followed in order to ensure proper,
efficient operation of your humidifier. The unit
will not work properly if not cleaned regularly.
When the unit is in use, daily and weekly maintenance is
recommended. Regular weekly cleaning prevents scale
buildup on the heating element and tray. It also prevents
micro-organisms from growing on the tray and tank. This
ensures that maximum efficiency will be achieved.
We cannot over-emphasize how essential proper
cleaning is to the maintenance and continued use
of your unit and to the avoidance of algae or
bacteria build-up
.