Consumer Safety Information - Sunbeam SWM6008-CN Instruction Leaflet

F E AT U R E S - O P E R AT I O N S
your warranty. The inside of the unit contains no user
serviceable parts. All servicing should be performed
by qualified personnel only.
21. Never place housing under water flow or immerse in
liquids.
22. Do not plug in the cord with wet hands: electric shock
could result.
23. Do not pour water in any openings other than the
water tank.
24. To prevent damage to surfaces, do not place
humidifier under overhanging surfaces.
25. NEVER operate unit without water in the tank.
26. Do not move unit after it has been used until unit
cools completely.
27. Use both hands when carrying full tank of water.
28. Failure to clean device per the cleaning instructions in
the instruction book may result in overheating or
fire.
PLEASE READ AND SAVE
THESE IMPORTANT
SAFETY INSTRUCTIONS

CONSUMER SAFETY INFORMATION

NOTE:
• This is an electrical appliance and requires attention
when in use.
• If moisture forms on the walls or windows of the
room, turn off the humidifier. The room already has
plenty of humidity and additional moisture may
cause damage.
• DO NOT block air inlet or outlet
• Keep unit away from surfaces that can be damaged
by water and/or heat (such as wood floors).
• Place mat underneath the unit during use.
• Do not place the humidifier on carpet. The heat sink
underneath the humidifier might cause the carpet to
be discolored and may cause overheating of the unit.
Cord and Plug Installation Safety
Instructions:
The length of cord used on this appliance was selected to
reduce the hazards of becoming tangled in, or tripping
over a longer cord. If a longer cord is necessary an
approved extension cord may be used. The electrical
rating of the extension cord must be equal to or greater
than the rating of the humidifier (refer to the rating
information placed on the humidifier). Care must be
taken to arrange the extension cord so that it will not
drape over the countertop or tabletop where it can be
pulled on by children or accidentally tripped over.
HOW WARM MIST WORKS
Your Sunbeam Warm Mist humidifier is designed to allow
®
the proper amount of water to flow out of the tank. Air is
drawn in through the grill openings located in the back of
the unit and mixed with steam in the misting chamber. The
warm mist is then dispersed out of the top of the misting
chamber through the outlet grill and into the room.
NOTE: A humidity level below 20% can be unhealthy and
uncomfortable. The recommended humidity level is
between 40%-50%.
PRE-OPERATING INSTRUCTIONS
1. Be sure the humidifier is switched off.
2. Select a location for your humidifier, on a flat level surface
about 4 inches (10 cm) away from the wall. DO NOT place
the humidifier on a finished floor or near furniture, which
can be damaged by too much moisture or water. Place on
a moisture resistant surface.
3. Remove the tank from the main housing.
4. Bring the tank to the sink, turn upside down and twist
off the tank cap by turning counter clockwise. Fill tank
with cool, fresh tap water. DO NOT fill with warm
water as this may cause leaking. Replace the cap on
tank FIRMLY. The tank will hold 1 gallon of water. The
humidifier will produce up to 2.5 gallons of water over
a 24 hour time period.
5. Make sure the safety lock is rotated completely to the
locked position. Place tank back on to the base. The
tank will immediately begin to empty into the base.