Replacing The Camera - Lenovo 300 Maintenance Manual

Step 13. Remove the five screws that secure the motherboard to the chassis and lift the motherboard
up to remove it.
Step 14. To install the new motherboard:
a. Line up the holes on the new motherboard with the mounting holes chassis and place the new
motherboard into position.
b. Use the screws to secure the new motherboard to the chassis.
c. Connect all the cables to the new motherboard.
Step 15. Install the following parts to the new motherboard:
• Wi-Fi card
• Heat-sink
• Memory module
Step 16. Reattach the EMI cover, rear cover, hinge, foot cover and stand base.

Replacing the camera

Note: Turn off the computer and wait 3 to 5 minutes to let it cool down before removing the cover.
Note: It may be helpful to place the computer face-down on a soft flat surface for this procedure. Lenovo
recommends that you use a blanket, towel, or other soft cloth to protect the computer screen from scratches
or other damage.
To replace the camera:
Step 1. Remove any media (disks, CDs, DVDs, or memory cards) from the drives, shut down the operating
system, and turn off the computer and all attached devices.
Step 2. Unplug all power cords from electrical outlets.
Step 3. Disconnect all cables attached to the computer. This includes power cords, input/output (I/O)
cables, and any other cables that are connected to the computer. Refer to "Left and right view"
and "Rear view" for help with locating the various connectors.
.
Chapter 8 Replacing hardware
47