Lexington Forge SAVANNAHSSW40 Owner's Manual page 16

MAINTENANCE
REMOVING FIREbRICk
To remove firebrick, lift up from bottom and rotate outward. See Figure 11.
GLASS CARE
REPLACE GLASS ONLy WITH HIGH TEMPERATURE CERAMIC
AVAILAbLE FROM yOUR LOCAL LEXINGTON FORGE DEALER
The following use and safety tips should be observed:
1. Inspect the glass regularly for cracks and breaks. If you detect a crack
or break, extinguish the fire immediately, and contact your dealer for
replacement.
2. Do not slam door or otherwise impact the glass. When closing doors,
make sure that logs or other objects do not protrude to impact the glass.
3. Do not clean the glass with materials which may scratch (or otherwise
damage) the glass. Scratches on the glass can develop into cracks or
breaks.
4. Never attempt to clean the glass while unit is hot. Light deposits are
normal. Heavier deposits may be removed with the use of a readily available oven cleaner.
5. Never put substances which can ignite explosively in the unit since even small explosions in
confined areas can blow out the glass.
6. This unit has an air wash system designed to reduce deposits on glass.
GASkET REPLACEMENT
After extensive use, the sealing material which provides glass and door seal may need to be replaced
if it fails to sustain its resilience. Inspect glass and door seal periodically to ensure proper seal:
if gaskets become frayed or worn, replace immediately. Contact your Lexington Forge dealer for
approved replacement parts. Refer to replacement parts list in this manual.
The following steps should be followed for glass gasket replacement:
1. Ensure appliance is not in operation and is thoroughly cooled
2. Remove door and place on a protected flat surface.
3. Remove screws and glass clips.
4. Lift glass out.
5. Remove old gasket and clean glass.
6. Sand gasket groove and wipe clean (rubbing alcohol works well).
7. Put a thin film of gasket cement on the door.
8. Replace new gasket starting at the top center of the door.
9. Trim to length and butt ends together. Remove all excess cement.
10. Replace glass in door, being sure not to over-tighten screws and clips.
The following steps should be followed for door gasket and ash pan door gasket replacement:
1. Ensure appliance is not in operation and is thoroughly cooled.
2. Remove door and place on a protected flat surface.
3. Remove old door gasket and clean channel.
4. Sand gasket groove and wipe clean (rubbing alcohol works well).
5. Using an approved high temperature gasket cement, apply a thin coat in bottom of channel.
6. Starting at top center of door, work into channel around door unit, trim to length and butt ends.
7. Close door and allow three to four hours for cement to set before restarting appliance.
16
Firebrick
Figure 11: Removing Firebrick
ST1018
remove firebrick
continued on next page
ST1018
63D4002