Advertisement
30} Connect the antenna feeder to the
wire
harness.
-1
Attach the feeder connector (Fig. 25}
to the frame using a wire band
oil
positioned where shown.
-2
Connect the feeder
(~)
to the wire
harness as shown.
31)
Check operation of each compoents as
follows:
-1
Check that the wire harnesses and
cables are routed properly and
are
not
pinched, twisted or pulled taut in
all
steering positions.
-2
Check that the radio is secure in its
mount, and that it can be removed
and installed easily with the key.
-3 Connect the battery negative cable to
the battery negative terminal.
-4
With the ign ition switch in the ACe
position, turn on the radio switch.
Check the radio and cassette deck for
proper operation.
-5
Recheck the harness and cable rout-
ings if there is any abnormality.
32) Check all bolts, nuts, screws and other
fasteners
for
security.
Retighten
if
necessary.
33) Install the headlight.
-1
Refer to Step 6 and Fig. 14.
NOTE: Check
that
the
headlight
aiming gears are engaged properly.
29) I nstall the antenna.
-1
I
nsta
II
the antenna feeder
@I
on the
antenna bracket
@l' .
using
the nut
,~
;
install the grommets
©
and
(g;
as
shown.
Pu II the end of the feeder
@
out/to
eli
m
i nate slack in the bracket
(fD .
NOTE:
Before
tightening
the nut
~iz
I
temporarily install the antenna
element
@
to be certain that it
can be folded toward the front.
-2
Position the antenna assembly on the
travel trunk stay as shown in Fig. 72.
NOTE:
• 0
iscard the grommet wh ich is re-
moved from the motorcycle.
• To
ease
installation, it is recom-
mended to remove the travel trunk.
Fig. 73
\
\
\MAIN WIRE HARNESS
j3)
/~
I
31
of
34
Advertisement
