Advertisement
Fig. 23
ANTENNA
FEEDER
GROMMET
COUPLER HOLDER
17) Route the antenna feeder into the fairing.
-1
Remove
the
grommet
from
the
coupler holder, and route the end of
the feeder through the large hole in
the holder, then trough the small
hole, into the fairing.
Reinstall the grommet.
NOTE:
Route the feeder
over
the
main amplifier
and
secure with the
wire clamp as shown.
,24
Fig. 25
HEX NUT
I
/
\
60NTROl BOX BLIND COVER
5 x 22 mm SOCKET HEAD BOLT
18) Install the auto
volume
control unit.
-1
Position the bracket
on the con-
trol unit
®
and install using a 5 mm
flange nut
Tighten the nut
securely.
-2
I nstall the control unit
on the
cover
using the hardware shown
in
Fig. 24.
NOTE: Install the plain washers with
ra ised ends facing
out.
-3
Connect
the
audio
harness
0
f
N
connector (red banded, Fig. 22) to the
auto
volume
control unit
0
I N
connector (red banded, Fig. 24).
-4
Connect
the
audio
harness
0 I N
connector (blue banded, Fig. 18} to
the auto volume control unit
DlN
connector
(blue banded, Fig. 24).
-5 Connect the
fairing harness white/
black coupler to the auto volume
control unit white/black coupler.
-6
Position the cover (see Step-2) on the
fairing and install using the 5 x 22 mm
screws retained in Step 2. Tighten the
screws securely.
-7
Press the caps
into the recesses of
the socket bolt heads.
Advertisement
