Advertisement
1=26
I
1
I
\
I
19) Install the clock~l and lock
'lJ
on the
meter visor.
Remove the blind covers from the
meter visor by pulling them out by
hand.
NOTE:
Discard the blind cover for
the clock.
Retain the blind cover
for the radio as it is used as a cover
when the rad io is removed.
-2
Remove the' nut from the clock
(~)
-3
Position the clock
!~;
and lock
(l~
on
the visor and install using the bracket
and
nut removved
in
Step-2.
Fig. 27
20) I nstall the seapkers
@
and meter visor on
the fairing.
-1
Slide the four clip nuts
@
onto the
edge of each speaker mount opening
of the fairing as shown.
-2
I nstall the seapkers using the hardware
shown in Fig. 27.
NOTE:
• Insta II the spacers
@
with the
sponge ends on the fairing side, and
the thick sides of the screw surfaces
facing out.
• Connect
the clock a nd speaker
harness wires noting the sizes of
the speaker wire terminals.
• Align the
locating tabs on the
meter visor with the holes in the
radio mount bracket.
• Install the speakers with the drain
holes facing up and down as shown.
13 of 34
Advertisement
