Mitsubishi Electric PAC-ZC40L Instruction Book page 43

2
Touch the [Mode] button to select one of the
following energy-save control modes that reduces
energy-consumption during vacancy.
The default setting is "Non-use."
• Non-use: Deactivates the energy-save control
assist function.
• Set temperature offset
• Fan speed down
*2
• ON/OFF: Turns off the unit.
• Zone control: Turns off the zones.
*1 When the units are operated in the Fan mode, the set
temperature will not be offset.
*2 If the connected indoor unit does not support the
fan speed adjustment function, this item will not be
displayed.
When the occupancy sensor detects occupancy
during the energy-save control, the original
operating status will be restored.
However, when the operating status is changed
by other controllers or by the scheduled or timer-
controlled events, the current operating status will
be retained even if the occupancy sensor detects
occupancy.
<Note>
• To use the energy-save control assist function in a
system with both main and sub remote controllers,
activate the function only on the remote controller
whose coverage area is the largest.
Function settings
: Offsets the set
*1
temperature.
: Sets the fan speed to "Low."
43