Makita DA4000LR Instruction Manual page 8

Remove the chuck remaining bolt through
the chuck opening by turning it counter-
clockwise with the hex wrench.
CAUTION:
The drill chuck and the bolt are assembled
each other. Turn the bolt counterclockwise
about 10 times so that they can be
removed together.
Loosen the bolts of the joint by the hex
wrench and remove the angle housing, the
joint and the socket.
To
install the socket and the joint, fit the
socket to the spindle so that the two faces
are fitted perfectly. Then install the joint.
For higher speed operation, fit the angle
housing marked "LOW" to the joint.
For lower speed operation, fit the angle
housing marked "HIGH" to the joint.
Loosen
r
Angle housing
Angle housing
Joint Socket
For higher speed operation
8