Table of Contents
Advertisement
POSITIONING THE HEATER
When positioning heater, the following conditions MUST be met! (See Figure 2.)
1.
The front of damper opening must be positioned BEHIND back edge of lintel to ensure proper draft. (See
Figure 2.)
2.
The vertical plane of fireplace front must fall BEHIND side panels of the unit. (In other words, it is possible
to have heater too far in as well as not far enough.)
3.
Center the heater in fireplace opening.
VERTICAL PLANE
LINTEL EDGE
FIGURE 2
POSITIONING
MOUNTING TRIM PANELS
After unit is positioned, mark mounting position of trim panels as follows:
1.
Place side trim panels flat against face of fireplace. Mark inside edge of trim panel to make a vertical
reference line. (See Figure 3.)
2.
Place top (long) trim panel on top of unit. The panel should be flat against outside face of fireplace, and
standing vertically. Mark lower edge of trim panel with a pencil to make a reference line for mounting.
3.
Slide unit out of fireplace far enough to work behind trim panel reference lines.
4.
Mount side trim panels. (See Figure 3.)
a. Position trim panel on reference line.
b. Drill mounting holes in center of trim panel mounting brackets to allow for adjustment in
and out if necessary.
c. Mount trim panel using self-tapping screws provided.
5.
Place top panel back on reference mark. Top trim panel mounting bracket is supplied with unit. Position
bracket so it overlaps rear lip of top trim panel. Drill mounting holes in top of stove using holes in bracket as
guide. Tighten screws.
6.
Follow installation procedures in listed direct connect or positive connect kit you are using and install heater
and connect kit in fireplace.
CENTER
LINE
DAMPER
OPENING
FIGURE 3 MOUNTING TRIM PANELS
Page 10
Hide quick links:
Advertisement
Table of Contents
