Toyota 2004 Sequoia Owner's Manual page 268

6. Test the operation of the HomeLink
pressing the newly programmed button.
Check to see if the gate/device oper-
ates correctly.
7. Repeat steps 1 through 6 for each re-
maining HomeLink R button to program
another device.
Programming other devices
To program other devices such as home
security systems, home door locks or
lighting, contact your authorized Toyota
dealer for assistance.
Reprogramming a button
Individual HomeLink R buttons cannot be
erased, however, to reprogram a single
button, follow the procedure "Programming
the HomeLink R ".
(b) Operating the HomeLink R
To operate the HomeLink R , press the
appropriate HomeLink R button to activate
the programmed device. The HomeLink
indicator light should come on.
HomeLink R continues to send the signal
for up to 20 seconds as long as the
button is pressed.
260
04_SEQUOIA_U (L/O 0309)
R by (c) Erasing the entire
memory (all three programs)
To erase all previously programmed codes
at one time, press and hold down the 2
outside buttons for 20 seconds until the
indicator light flashes.
If you sell your vehicle, be sure to erase
the programs stored in the HomeLink
memory.
R
The
HomeLink R
CAUTION
When programming the HomeLink
D
Universal Transceiver, you may be
operating a garage door or other
device. Make sure people and ob-
jects are out of the way of the ga-
R
rage door or other device to pre-
vent potential harm or damage.
Do not use this HomeLink
D
sal Transceiver
door opener that lacks the safety
stop and reverse feature as re-
quired by federal safety standards.
(This includes
opener model manufactured before
April 1, 1982.) A garage door open-
er which cannot detect an object
(signaling the door to stop and re-
verse), does not meet current feder-
al safety standards. Using a garage
door opener without these features
increases risk of serious injury or
death.
2004 SEQUOIA from Sep. '03 Prod. (OM34423U)
R
R Univer-
with any garage
any garage door