Toyota 2004 Sequoia Owner's Manual page 254

2. Bi−level—Air flows from both the floor
vents and the instrument panel vents.
When you set the temperature selector
setting at about the middle in automatic
operation, warm air flows out of the
floor vents and relatively low−tempera-
ture air flows out of the center and
side vents.
3. Floor—Air flows mainly from the floor
vents.
It is recommended that you close the
lower vent. For details about this, see
"Instrument panel vents" on page 251
in this Section.
4. Floor/Windshield—Air flows
from the floor vents and windshield
vents.
Use with the air intake selector posi-
tioned in FRESH.
It is recommended that you close the
lower vent. For details about this, see
"Instrument panel vents" on page 251
in this Section.
For details about air flow selector settings,
see "—Air flow selector settings"
scribed below.
246
Windshield air flow button
mainly
When this button is pressed, air flows
mainly from the windshield vents.
Pressing the button once again returns the
air flow mode to the last one used.
This button allows the air intake to select
FRESH automatically. This is to clean up
the front view more quickly. If you want
to return the setting to RECIRCULATE
mode, press the air intake selector button
once again.
Press the "A/C" button for dehumidified
de-
heating or cooling. This setting clears the
front view more quickly.
04_SEQUOIA_U (L/O 0309)
It is recommended that you close the low-
er vent. For details about this, see "Instru-
ment panel vents" on page 251 in this
Section.
For details about air flow selector settings,
see "—Air
scribed below.
For further information for removing frost
and fog, see "Instrument panel vents" on
page 251 in this Section.
2004 SEQUOIA from Sep. '03 Prod. (OM34423U)
flow selector settings" de-