Installation Instructions - Teka LP8835W Instruction Manual

Instruction Manual
Installation
Instructions
It's important to carefully read the following installation instructions before beginning the
installation of your dishwasher.
Important! The installation of the pipes and electrical outlets should be completed by
suitably licensed and qualified persons.
Positioning
— The installation position of the dishwasher should be near the existing inlet, drainage
wastepipe and power outlet.
— Choose a position near your sink to facilitate the installation of inlet and drain hoses
(refer to figure one).
— If the dishwasher is installed in the corner of your kitchen cabinetry, make sure an
allowance is made to ensure your dishwasher door can freely open without obstruction
from other cabinetry/door handles.
Cold Water Connection
— Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure
that it is fastened tightly in place.
— If the water pipes are new or have not been used for an extended period of time, let the
water run to make sure that the water is clear. This precaution is needed to avoid the
risk of the water inlet to be blocked and damage the appliance.
Connection of the drain hose
— Insert the drain hose into a drain pipe with a minimum diameter of 40mm, or connect it
onto the trap of your sink where a dishwasher connection is present.
Important! The top of the hose must be less than
1000mm, as illustrated below.
Note: If you require a longer drain hose, make
sure you use a similar drain hose. It must
be no longer than 4 metres; otherwise the
performance of the dishwasher will be
effected.
13