Front Flare Element Rear Flare Element Screws User Manual Intended use The Master Anamorphic Lens Flare Sets are designed to be used on ARRI/ZEISS Master Anamorphic lenses. Each Flare Set should only be used on the specified focal length. Safety tips Caution To ensure proper and safe use, we recommend that you read these safety and operating instructions before using the product and then store them.
Page 3
T4 torque wrench (same procedure as with the lug nuts on your car). 3. ZEISS uses locking varnish on the screws. As you remove the screws from the lens we recommend to throw them away. Otherwise particles of the dried locking varnish could soil the lens.
Page 4
Flare Set User Manual Assembly instruction for front group Untighten the front trim ring with the friction wrench and remove it by hand (Fig.2). Undo the Torx T4 screws in the compendium/matte box ring and carefully pull it off (Fig. 3). Undo the inner Torx T4 screws, which hold the front lens element, and remove this element (Fig.1).
Page 5
Master Anamorphic Lens 135/T1.9 Assembly instruction for rear group Undo the Torx T4 screws from the rear trim ring and pull the trim ring off (Fig.4). Undo the inner Torx T4 screws in the rear element (Fig.5) and carefully remove the element (Fig.3). Insert the new rear element and tighten the Torx T4 screws (Fig.5).
Page 7
In no event shall ARRI/ZEISS or its subsidiaries be liable for or have a remedy for recovery of any special, direct, indirect, incidental, or consequential damages, including, but not limited to lost profits, lost savings, lost...
Need help?
Do you have a question about the Arri 135/T1.9 and is the answer not in the manual?
Questions and answers