(1) Hot dash is engaged if the difference between the room temperature and set temperature is equal to that between the room temperature, at which the compressor reaches maximum speed, and set temperature (ÆTWMAX: See Table 7), and

the room and outdoor temperatures are less than 10ûC; when the fan speed is ÒautoÒ, operation is started at ÒHiÒ, or the fan speed is changed to ÒHiÒ during heating.

(2) The maximum compressor speed period during hot dash is finished (1) when the room temperature reaches the heating set temperature (including heating shift) when the thermo is off.

(3) The thermo OFF temperature during hot dash is heating set temperature (including heating shift) plus 3ûC. After thermo OFF, hot dash finishes, and PI control starts with item I = 0.

(4) The compressor minimum ON time and minimum OFF time is 3 minutes.

(5) The time limit for which the maximum compressor speed during normal heating (except for hot dash) can be maintained is less than 120 minutes when the room temperature is 18ûC or more; it is not provided when the room temperature is

less than 18ûC and outdoor temperature is less than 2ûC.

(6) The operation indicator blinks every second during initial cycle operation, preheating, defrosting (including balance time after defrosting is finished), or auto fresh defrosting.

(7) If the room temperature falls to less than 18ûC in the Òultra-LoÒ mode, the indoor fan stops. When the room tempereture is 18ûC+0.33ûC or more, the ultra-Lo operation restarts. However, the ultra-Lo operation during preheating or preheating

after defrosting does not stop if the room temperature is less than 18ûC.

(8) When thermostat is OFF ; after 3 minutes has elapsed operation with FAN set to ON for 15seconds and OFF for 60seconds will be repeated depending on heat exchange temperature.

asic Heating Operation

Stop

Start

Thermo

OFF

30sec.

10sec.

30sec.

15sec.

Control by

Control by heat exchanger

heat exchanger