Advertisement
4. Instructions
(1) On the proper adaptation of the reaction bar to the application.
(2) Use only sockets and adapters which are in good condition and are intended for use with power
tools.
(3) Ensure that the assembly power tool is securely fixed to suspension advice, if used.
(4) Adopt a suitable postures to counteract normal or unexpected movement of the power tool due to
reaction forces from the power assembly tool.
(5) Ensure that the pressure of the air or fluid supply is not lower than the lowest pressure specified by
the manufacturer for clutch controlled assembly tools and make sure that the air or fluid supply
pressure does not fail after the clutch has been set.
(6) Release the start and stop device in the case of an interruption of the energy supply.
(7) Only lubricants recommended by the manufacturer shall be used.
5. Explanations Of Warning Signs Used For This Tool
The operator's
Risk of crushing
instruction must
be read before
work starts
6. Application
Rotary power tool, with a reversible spindle driving a hammer which periodically strikes an anvil which
includes a drive adapter for the purpose of tightening or loosening nuts and bolts without producing
any major torque reaction on the power tool.
7. The weight of this tools:
Model No.:
Weight
Note：If the weight of this tool exceeds 15 Kgs, the following attention shall be paid to：
(1)
Be sure that you can afford the weight.
(2)
Be sure to wear foot protection, to prevent the risk of impact due to the drop of tool.
Revision date 10/2015
Warning:
Warning: Risk of
crushing (between
(intended for
the reaction bar
open-ended
and the working
spanners)
piece)
IW-PRO 3/4"
IW-PRO 1"
10.6 kg
Direction of
rotation
IW-PRO 1/2"
5.84 kg
2.64 kg
4.
Advertisement
