Table of Contents
Advertisement
23.Measure:
• Distance "a"
Out of specification → Turn into the locknut.
Distance "a":
16 mm (0.63 in) or more
Between the damper assembly "1"
bottom and locknut "2" bottom.
24.Install:
• Collar "1"
• Fork spring "2"
To damper assembly "3".
Install the collar with its larger dia. end "a" fac-
ing the fork spring.
25.Install:
• Damper assembly "1"
To inner tube "2".
To install the damper assembly into the in-
ner tube, hold the inner tube aslant. If the in-
ner tube is held vertically, the damper
assembly may fall into it, damaging the
valve inside.
26.Loosen:
• Rebound damping adjuster "1"
• Loosen the rebound damping adjuster finger
tight.
• Record the set position of the adjuster (the
amount of turning out the fully turned in posi-
tion).
27.Install:
• Push rod "1"
• Copper washer "2"
• Adjuster "3"
To damper assembly "4".
• While compressing the inner tube "5", set the
cap bolt ring wrench "7" between the inner
tube and locknut "6".
• Fully finger tighten the adjuster onto the
damper assembly.
Cap bolt ring wrench:
YM-01501/90890-01501
5-32
FRONT FORK
Advertisement
Table of Contents
