Honda 08E91-E22-101A Installation Instructions Manual page 8

24. Remove the vehicle bolt and remove the TPMS
control unit from the vehicle bracket.
TPMS CONTROL UNIT
STEERING
SHAFT
25. Route the 12-pin/8-pin/5-pin connector end of the
engine starter harness over the brake pedal bracket
towards the center of the vehicle.
ENGINE STARTER
HARNESS
BRAKE PEDAL
BRACKET
12-PIN/8-PIN/5-PIN CONNECTOR
8 of 23
VEHICLE
BRACKET
VEHICLE
BOLT
6D18091Y
STEERING
SHAFT
VEHICLE
BRACKET
6D1810AY
26. Route the 12-pin/8-pin/5-pin connector end of the
engine starter harness to the ignition switch.
5-PIN
CONNECTOR
2
Pull.
Push.
Unlock Connector
27. Disconnect the vehicle 5-pin connector from the
ignition switch, and plug the engine starter harness
5-pin connector into the ignition switch.
NOTE: Check that the engine starter harness 5-pin
connector is securely connected to the vehicle
connector. A loose connector can cause the engine
to stall.
AII 46522 (1108)
VEHICLE 5-PIN
CONNECTOR
IGNITION
SWITCH
ENGINE STARTER
HARNESS
2
1
Push.
3
Lock Connector
© 2011 American Honda Motor Co., Inc. – All Rights Reserved.
12-PIN/8-PIN/5-PIN
CONNECTOR
1
6D1812DY