Sony KDF-60XBR950 Service Manual page 10

3. Blinking count display of POWER/STANDBY indicator
- Release of POWER/STANDBY indicator blinking
The POWER/STANDBY indicator blinking display is released by removing the plug from
the power or leaving for 2 minutes.
4. Self-diagnosis screen displays
- In cases of malfunctions where it is not possible to determine the symptom such as when
the power goes off occasionally or when the screen disappears occasionally, there is a
screen display on whether the malfunction occurred or not in the past (and whether the
detection circuit operated or not) in order to allow confirmation.
<Screen Display Method>
- Quickly press the remote command button in the following order from the standby state.
DISPLAY
MAIN
Self Diagnosis
6 : +B OVP
7 : AUDIO
8 : D-OVP
101 : WDT
- Numeral "1" means a fault was detected one time or more.
- Numeral "0" means that no fault was detected.
- One blink is not used for self-diagnosis.
- Example
Diagnosis item LED blinks
Lamp cover
Fan
LED ON : 0.3sec
LED OFF : 0.3sec
Channel 5
0
0
1
0 Move the joystick
– 9 –
K
3 times
4 times
Vol -
Be aware that this differs from
the method of entering the
service mode (Vol +).
LCD ENGINE
SELF DIAGNOSIS
1 : LAMP
3 : LAMP COVER
4 : FAN
4 : TEMP
5 : LAMP DRIVER
201 : WDT-ENGINE
KDF-60XBR950/70XBR950
RM-Y914
LED OFF
3.0sec
POWER
0
0
1
0
0
0
RM-Y914