Intex ECO 20110 Owner's Manual page 28

POOL MAINTENANCE & CHEMICAL DEFINITIONS
Free Chlorine
Combined Chlorine
pH
Total Alkalinity
Calcium Hardness
Stabilizer (Cyanuric Acid)
Consult with local swimming pool dealer for water treatment.
Free Chlorine
Combined Chlorine
pH
Total Alkalinity
Calcium Hardness
Stabilizer
(Cyanuric Acid)
• Do not add pool chemicals directly to the skimmer. This may damage the cell.
• Maintaining a salt and sanitizer level above the recommended range can contribute to the
corrosion of the pool equipment.
• Check the expiry date of the test kit as the test results may be inaccurate if the kit is used after
that date.
• If, due to heavy pool usage, it is required to increase the sanitizer level, then use a chemical
based on trichlor, TCCA or dichloro.
SAVE THESE INSTRUCTIONS
(261PO) Sand Filter Pump & Saltwater System with E.C.O. ENGLISH 7.5" X 10.3" PANTONE 295U 07/23/2014
Preferred Water Chemistry Reading
Minimum
0
0
7.2
40 ppm
50 ppm
10 ppm
-
Is the chlorine residual present in pool water.
-
Is formed by the reaction of free chlorine with ammonia wastes.
Result if too high - Sharp chlorinous odor, eye irritation.
-
A value that indicates how acidic or basic a solution is.
Result if too low - Corroded metals, eye & skin irritation, destruction of
total alkalinity.
Result if too high - Scale formation, cloudy water, shorter filter runs,
eye & skin irritation, poor chlorine efficiency.
-
Indicates the degree of the water's resistance to change in pH.
It determines the speed and ease of pH change, so always adjust total
alkalinity before adjusting the pH level.
Result if too low - Corroded metals, eye & skin irritation. Low alkalinity
will cause the pH to be unstable. Any chemical
added to the water will have an affect on pH.
Result if too high - Scale formation, cloudy water, eye & skin
irritation, poor chlorine efficiency.
-
Refers to the amount of calcium and magnesium dissolved in the water.
Result if too high - Eye & skin irritation, difficulty balancing water and
poor chlorine efficiency. Scale will form and will
cause the water to become cloudy.
-
Stabilizers extend the life of chlorine in swimming pools.
Ideal Maximum
0.5 - 3.0 ppm 5.0 ppm
0 ppm 0.2 ppm
7.4 - 7.6 7.8
80 ppm 120 ppm
100 - 250 ppm 350 ppm
20 - 40 ppm 50 ppm
261
English
PO
Page 28