Intex ECO 20110 Owner's Manual page 17

SALTWATER SYSTEM OPERATION
1. Start up the unit:
Plug the power cord into the electrical outlet and test the GFCI/RCD
(circuit breaker). Switch on the unit. With the Filter Pump turned "ON"
and operating. Flashing code"00" appears on the electronic control
station's LED, indicating that the unit is ready to be programmed.
2. Set operating hours for Saltwater System:
With code "00" flashing, press
desired operating hours. See the "Operating Time Table"
for the required operating hours related to each pool size.
Pressing will increase the time from 01 to 12 hours
maximum. If you have selected too many hours keep
pressing to repeat the cycle. The built-in timer will
now activate your Saltwater System, at the same time
each day, for the number of hours you have set.
NOTE: The Saltwater System will not operate if the filter
pump is not operating.
3. Lock keypad controls:
With the desired hour value showing, press
"beep". The green "WORKING" indicator on the control panel will light up
within a few seconds to indicate that the saltwater system has started
sanitizer production. Locking the control buttons into this setting prevents
unauthorized changing of the operating cycle.
NOTE: If you forget to lock the keypad controls, the system will
automatically lock it and start working 1 minute later.
4. Readjust operating time if necessary:
The operating hours can be re-adjusted if necessary. Press
until you hear a "beep" to unlock the keypad and the current
programmed time will flash. Repeat steps 2 to 3.
SAVE THESE INSTRUCTIONS
(261PO) Sand Filter Pump & Saltwater System with E.C.O. ENGLISH 7.5" X 10.3" PANTONE 295U 07/23/2014
button to set the
button until you hear a
English
(1 to 12 hours max per cycle)
button
Page 17
261
PO