Table of Contents
Advertisement
Rear Panel Features
This is the stuff on the rear panel...
1. INPUT - Two, RCA jacks. Stereo or mono audio sensing line level audio input. A100 will
turn ON when a line level audio signal is present on either jack. Amp will turn OFF after 15
minutes of no audio signal.
2. TRIGGER - One, 3.5mm mini jack. Connect to the DC voltage Control OUT on an amplifier,
AV Receiver or other audio processor to automatically turn the A100 ON/OFF. When DC
voltage is applied, the A100 will turn ON. When DC voltage is removed, the A100 will turn
OFF. RANGE: +12 to +24V DC. POLARITY: Tip: +VDC, Sleeve: GND.
3. SPEAKER OUT - Two, gold spring push terminals. Connect to a passive subwoofer or a
powered sub with speaker level input.
4. 110/220V - One, switch. Select either 110V-120V or 220V-240V as appropriate for local
AC line voltage. Please confirm local voltage prior to use or making changes to the setting.
5. POWER - One, switch. Set to ON position to turn power to the amp ON. Set to OFF position
to turn power to the amp OFF.
6. AC MAINS - One, three-prong socket. Use the supplied 3-pin ground power cable to
connect the unit to an external AC power supply.
1
2
INPUT
SPEAKER OUT
L
TRIGGER
R
3
4
5
POWER
ON
OFF
AC INPUT
110-120V 60Hz;220-240V 50Hz 150W
FUSE:110-120V,T2AL/250V
FUSE:220-240V,T1AL/250V
7
6
Advertisement
Table of Contents
